Configuring Devices; Figure 3-34 Notification Callback Setup Screen - Honeywell HRXD9 User Manual

Configuration
10. Highlight LAN and press
11. Highlight the IP Address box that you want to change and press
12. Highlight the box beside Retry and enter the number of times you would like the
13. If the modem was enabled in the Network screen, you can set up the DVR to
14. Highlight the box beside Remote Server Phone Number and enter the telephone
15. Highlight the box beside Outside Line Call and enter any numbers that must be
16. Highlight the box beside Callback Phone Number and enter the telephone
17. You can save your Notification changes by highlighting Save and pressing

Configuring Devices

You can configure the video, audio, alarm, display and remote control devices
connected to the DVR.
Document 900.0856 Rev 3.00
11/07
Figure 3-34
On you can change the IP addresses.
address of the computer you want contacted during an event. You can enter up to
five IP addresses.
DVR to try contacting the computer(s). You can select from 1 to 10 retries.
contact a computer running RAS. Highlight Modem and press
between On and Off. When Modem is turned On you can enter a telephone
number.
number of the computer running RAS.
dialed for an outside line to function on your telephone system; for example, 9.
number of the DVR.
Selecting Cancel exits the screen without saving the changes.
Notification Callback Setup Screen
to toggle between On and Off. When LAN is turned
. Enter the IP
to toggle
.
61