Table of Contents
Advertisement
Digital Video Recorder
Callback Center Setup by Modem connections
Figure 64 — Callback Center (Modem) Setup screen.
Highlight the box beside Pager Number and enter the telephone number of the pager. Enter
the number as it must be dialed from your telephone system; for example,, if you must dial "9"
for an outside line, enter "9" before the pager number.
Highlight the box beside Mailbox and enter the voice mailbox number if your pager uses a
voice mailbox.
Highlight the box beside Site ID and enter a three-digit site ID number.
When an event occurs, the DVR will dial the pager and leave a four-digit number. The first
three digits are the site ID number and the last digit is the type of event (1: Alarm In, 2: Motion
Detection, 3: Video Loss, 10: Storage is Bad and 12: S.M.A.R.T Alert). For example, "0753"
means that Site 75 has lost video.
NOTE: The DVR will wait for at least four minutes between pages. If another event
occurs less than four minute after the DVR has notified a pager, it will not dial the pager.
It does this so that the telephone line will not be tied up.
You can save your changes by highlighting OK and pressing the
button . Selecting Cancel
exits the screen without saving the changes.
57
Advertisement
Table of Contents
