Table of Contents
Advertisement
User' s Manual
DUPLEX LED
The DUPLEX LED is lit when the DVR is operating in the Duplex mode.
PTZ Button
Pressing the
PTZ
button opens a Pan/Tilt/Zoom screen which allows you to control properly
configured cameras.
MODE/TELE Button
Pressing the
MODE/TELE
formats are: full, 4x4, 3x3, 2x2 and PIP. Zooms In in PTZ mode.
SEQUENCE/WIDE Button
When in the live mode, pressing the
channel sequentially. When in one of the multi-view formats, pressing this button will cause the
DVR to sequence cameras in two sequence modes: "Page" and "Cameo". In the Page mode, the
DVR sequences through user-defined screen layouts (pages). In the Cameo mode, the bottom,
right screen to display live cameras sequentially. Pressing the
in the Sequence mode will exit the Sequence mode. Zooms Out in PTZ mode.
FREEZE/FAR Button
Pressing the
FREEZE/FAR
mode.
ALARM/NEAR Button
The
ALARM/NEAR
the internal buzzer during an alarm. Second, it will display the event log when you are in the
live monitoring mode unless there is an active alarm. This operation can be user password
protected. Used for near Focus in PTZ mode.
The
ALARM/NEAR
alarm outputs by pressing the
output is activated again.
SPOT/PRESET Button
Pressing the
SPOT/PRESET
selected camera on the spot monitor. For the sequence display on the spot monitor, press the
button and then
SPOT/PRESET
12
button toggles between different display formats. The available
SEQUENCE/WIDE
button freezes the current live screen. Used for far Focus in the PTZ
button has two functions. First, it will reset the DVR's outputs including
button LED is lit when alarm outputs are activated. When the user resets
ALARM/NEAR
button and pressing the individual camera buttons displays the
SEQUENCE/WIDE
button displays another full live
SEQUENCE/WIDE
button, the button LED will not be lit until alarm
button. Saves Presets in PTZ mode.
button while
Advertisement
Table of Contents
