Setting Unit For Ntsc Or Pal; Connecting The Video Source; Connecting The Loop Through Video; Figure 3 - Ntsc/Pal Switch - Samsung SHR-3091 User Manual

User' s Manual

Setting Unit for NTSC or PAL

Figure 3 — NTSC/PAL switch.
Your DVR can be used with either NTSC or PAL equipment. Before turning on the DVR, set
the switch to NTSC or PAL to match your equipment.
NOTE: You cannot mix NTSC and PAL equipment. For example you cannot use a PAL
camera and an NTSC monitor.
CAUTION: If you set the switch from NTSC (PAL) to PAL (NTSC), please do the
Factory Reset and Clear All Data. If not, it causes the DVR to perform wrong
operations.

Connecting the Video Source

Figure 4 — Video input connectors.
Connect the coaxial cables from the video sources to the BNC Video In connectors.

Connecting the Loop Through Video

Figure 5 — Video Loop Through connectors.
If you would like to connect your video source to another device, you can use the Loop BNC
connectors.
NOTE: The Loop BNC connectors are auto terminated. Do NOT connect a cable to the
Loop BNC unless it is connected to another terminated device because it will cause poor
quality video.
4