Maintenance Settings - Star Trac Pro S Owner's Manual

PROCEDURE
Apply wax powder while belt & deck are still warm (5 minutes minimum use) for optimum benefit.
1. CAUTION: TURN TREADMILL POWER OFF AND UNPLUG THE POWER CORD BEFORE REWAXING THE BELT.
2. CLEAN DECK & BELT:
A. Using the paint stick or ruler, slide a towel under the middle of the belt from one side of the frame to the other.
B. Hold the edges of the towel; pull to the tailroller; pull to the headroller; then pull the belt down to wipe the remaining belt.
TIP: Fold the dirty towel and shake into trash.
3. LIFT BELT: Lift the left side (facing display) of the belt, about 12 inches down from the motor shroud (see figure). Hold the
belt up to elevate the belt from the deck.
4. SPREAD WAX: Flip the nozzle on the cap of the wax bottle. Point the nozzle at the deck. Be sure that the bottle is tilted at a
downward angle. Squeeze the wax bottle twice between the running belt and the deck. TIP: Gently shake the bottle between
each squeeze.
5. Repeat steps 3 and 4, about 18 inches from the end of the deck.
6. Repeat steps 3 through 5, on the right side of the belt/deck.
7. WALK: Plug in the treadmill. Turn the treadmill ON/OFF switch to the ON position. Start the treadmill at 1 mph and walk
on all sections of the belt and deck for 1 minute to ensure the wax has been evenly distributed and worked-in properly.
8. CLEANUP: Turn the treadmill power OFF . Remove any excess wax with diluted cleaner (409) and towel. TIP: Blow away
extra wax first (like dust), then wipe.
9. DISPLAY UPDATE: Update the LAST DECK service mileage to remove the REWAX BELT message.
A. Power ON the treadmill.
B. Enter MAINTENANCE SETTINGS (see Chapter 8).
C. Press the INCLINE DOWN key until the Information Window reads LAST DECK.
D. Use the 0 ~ 9 keys to enter the present treadmill distance.
E. Press the S key to enter and update the display.
TART
F. Press the S key to exit MAINTENANCE SETTINGS.
TOP
38 STAR TRAC PRO S / PRO / TREADMILL O
ELITE WNER
' M
S ANUAL