Star Trac Pro S Owner's Manual page 14

2. Installing the Neck
Remove the four pre-installed neck mounting screws and washers
from the motor shroud end of the frame assembly.
Position the neck in place on the motor shroud end of the frame
assembly, and re-install the four screws and washers to secure.
3. Removing the Motor Shroud
Remove the 10-24 screws securing the motor shroud to the frame assembly, and lift the motor shroud off of the frame
assembly. Retain the screws for use when re-installing the motor shroud.
4. Installing the Display
Caution: To ensure proper routing of the display cables, it may be necessary to have one person support and position
the display while a second person feeds the display cables through the neck assembly.
With two people supporting the display, carefully feed the display cables into the neck. Reposition the display as needed
during this step to ensure the display cables do not bunch or kink in the neck. Ensure the display cables feed completely
through, and out the bottom, of the neck.
12
Step 2b
MOTOR
SHROUD
Step 3
STAR TRAC PRO S / PRO / ELITE TREADMILL O
NECK MOUNTING
SCREWS AND WASHERS
Step 2a
' M
WNER S ANUAL