A/V Install - Wire Management - Star Trac Pro S Owner's Manual

For the Bike, CrossTrainer, and Stepper, a rubber extrusion piece is included for
wire management during the AV install.
To install:
- Clean mounting surface with isopropyl alcohol or equivalent.
(Do not use an oil based cleaner.)
- Push wires through slitted gap until fully enclosed.
- Peel off adhesive tape cover of the velcro on the underside of the wire man-
agement of about 4 inches from the top end.
- Align wire management to center of mounting surface just right below the
bracket clamp and continue peeling off adhesive tape cover at about 6-8
inches at a time, while pressing down firmly on the wire management in
between.
Refer to pictures for step-by-step process.

A/V Install - Wire Management

Bike, CrossTrainer and Stepper
27 27