Maintenance Settings.59 - Star Trac 4500 Owner's Manual

Maintenance Settings
Maintenance Settings includes all of the items in Manager Settings, plus additional items for
Service and Diagnostic use. Your Service Representative may need to check accumulated data
about the past usage of your treadmill, test its motor and display controls, or investigate error
messages. For these reasons, your treadmill is equipped with Maintenance Settings. To enter
Maintenance Settings:
• Press and
hold
QJ, £J,
and |
START]
together.
• Release j*J.
• Listen for a beep and see MAINTENANCE SETTINGS in the display momentarily.
• Release the remaining keys. See UNITS in the Alphanumeric Display.
The following keys are available in MAINTENANCE SETTINGS:
INCLINE Keys: Display the next and previous data item, respectively. Keys will
repeat if held.
SPEED
Keys: Adjust the value of the displayed data item up and down, respectively,
in increments of 1 unit or 0.01 unit, as appropriate for the data item. They do not save
the new value - see
[START]
below.
START Key: Updates (saves) the value of the displayed data item in erasable programmable
read-only memory (EPROM).
STOP
Key: Exits Configure Mode and restarts the treadmill greeting.
Number/Program Select Keys: Enter new data item values. If the UNITS data
item is displayed, starts Display Test Mode and [z] starts Motor Test Mode.
Heart Rate Key: Displays the default value of the item, whereafter you may save it
u§ing
[START]
Exception: Displays DISTANCE instead of 0 for LSTDCK and LSTBLT.
Use
Q
and
[START]
to reset the "error" data items to zero after service. These items are
NO STO through EL NOZ and LSTERR through LST TM in the list below.
To leave MAINTENANCE SETTINGS , press
[STOP]-
STAR TRAC 4500 TREADMILL Owner's Manual S3