Port No - Konica Minolta BIZHUB 500 User Manual
Network scanner operations
Hide thumbs
Also See for BIZHUB 500:
- Service manual (958 pages) ,
- User manual (794 pages) ,
- Shortcut manual (24 pages)
Table of Contents
Advertisement
Specifying Settings From the Control Panel
Port No.
Specify the port number that other systems access using OpenAPI (initial
port number: 50001, initial port number (SSL): 50003).
1
In the Administrator Setting screen, touch [System Connection]. (Refer
to "To display the Administrator Setting screen" on page 4-10 for more
details.)
2
In the System Connection screen, touch [1 OpenAPI Setting].
3
In the OpenAPI Setting screen, touch [Port No.].
The OpenAPI Port Setting screen appears.
4
Press the [C] (clear) key to erase the value, and then use the keypad to
type in the value (between 1 and 65535).
–
If a value outside of the allowable range is specified, the message
"Input Error" appears. Type in a value within the allowable range.
5
Touch [OK].
–
To cancel changes to the setting, touch [Cancel].
The port number that other systems access using OpenAPI is set.
Note
If the port number for SSL communication is specified, the certificate
must be pre-installed from PageScope Web Connection. For details,
refer to "SSL/TLS" on page 5-103.
bizhub 500/420 (Phase 2)
4
4-157
Advertisement
Table of Contents
