Table of Contents
Advertisement
9. Close Front Cover R to allow you to see the gap between the Printer and
Container Stacker. Using the leveling bolts, adjust the height of the Container
Stacker until the Container Stacker frame projection is level with the Printer
Paper Guide projection. Adjust the horizontal level of the Container Stacker by
placing a level on the stacker frame in the three locations shown below. Tighten
the screws completely.
Stacker Frame
Printer Paper Guide
Level
Projection
Projection
Same Height
Connection Part Details
Front Cover L
Leveling Bolts
10. Verify the gap at A, B, C, and D is nearly equal.
Adjust the parallel gap
A
C
B
D
Container Stacker Installation Instructions 1-15
Advertisement
Table of Contents
