Ricoh Container Stacker Unpacking & Setup Instructions page 11

6. Romove the tape from the leveling bolts, take out the four wooden spacers from
the accessory box, and place them at the bottom of the bolts (under the plastic
bag).
7. Using an open-end wrench, raise the container stacker by rotating the leveling
bolts.
Wood spacer
Leveling bolt
8. Remove the 4 pieces of base packing.
9. Turn all the casters in the same direction.
10. Install the ramps (two on each side) under the incline board.
1-6 Container Stacker Installation Instructions
Down
Up
Ramp
Incline Board