Ricoh Container Stacker Unpacking & Setup Instructions page 10

2. Remove the accessory box, spacer box, spacer packing, ramps and upper packing.
3. Remove the shipping box, band, and four corner pieces.
4. Peel off the adhesive tape and remove the plastic bag.
5. Cut the tape from the 4 corners of the base packing and push down the side of the
pallet to become an incline board.
Spacer box
Spacer packing
Ramp
Upper packing
Shipping box
Plastic bag
Corner packing
Base packing
Cap
Spacer packing
Ramp
Upper packing
Accessory box
Spacer box
Corner packing
Base packing
Pallet
Container Stacker Installation Instructions 1-5