Agilent Technologies 81101A Reference Manual page 51

have to execute [:SOURCE]:HOLD CURRent command to enable the
[:SOURCE]:CURRent subsystem.
The available current range is limited by the combination of:
• Specified Voltage limits
• Actual OUTPUT Impedance setting :OUTPut:IMPedance
• Actual Expected Load impedance setting:
:OUTPut:IMPedance:EXTernal
To program the high level current of the output signal:
:HOLD CURR
:CURR:HIGH 150MA
:CURR[1]:LOW
[:SOURce]:CURRent[1][:LEVel][:IMMediate]:LOW
Set & Query
Numeric
A with engineering prefixes.
Amplitude = High – Low
High – Low
Offset =
High level
–10 mA (50 into 50 )
10 V Outputs (from high Z into short): –400 mA to 396 mA typical
3.8 V Outputs (from 50
Use this command to program the low level current of the OUTPUT
signal. Note that to set the OUTPUT levels in terms of current, you first
have to execute the [:SOURce]:HOLD CURRent command to enable
the [:SOURce]:CURRent subsystem.
The available current range is limited by the combination of:
Enable CURRENT subsystem
Set OUTPUT high level to 150 mA
2
into short): –84 mA to 150 mA typical
51