Agilent Technologies 81101A Reference Manual page 49

Amplitude = High – Low
High – Low
Offset =
Offset
Use this command to program the amplitude current of the OUTPUT
signal. Note that to set the OUTPUT levels in terms of current, you first
have to execute the [:SOURce]:HOLD CURRent command to enable the
[:SOUR ]:CURR
CE ENT
The available current range is limited by the combination of:
• Specified Voltage limits
• Actual OUTPUT Impedance setting :OUTPut:IMPedance
• Actual Expected Load impedance setting:
:OUTPut:IMPedance:EXTernal
To program the amplitude current of the output signal:
:HOLD CURR
:CURR 75MA
:CURR[1]:OFFSet
[:SOURce]:CURRent[1][:LEVel][:IMMediate]:OFFSet
Set & Query
Numeric
A with engineering prefixes.
0.0 A (50 into 50 )
Amplitude = High – Low
High – Low
Offset =
2
subsystem.
Enable CURRENT subsystem
Set OUTPUT amplitude to 75 mA
2
49