Troubleshooting Ip Source Guard; Failed To Configure Static Binding Entries And Dynamic Binding Function - 3Com 4510G Configuration Manual

[SwitchA-GigabitEthernet1/0/1] display dhcp-snooping
DHCP Snooping is enabled.
The client binding table for all untrusted ports.
Type : D--Dynamic , S--Static
Type IP Address
==== =============== ============== ============ ==== =================
D 192.168.0.1
As you see, port GigabitEthernet 1/0/1 has obtained the dynamic entries generated by DHCP snooping
after it is configured with dynamic binding function.

Troubleshooting IP Source Guard

Failed to Configure Static Binding Entries and Dynamic Binding Function

Symptom
Configuring static binding entries and dynamic binding function fails on a port.
Analysis
IP Source Guard is not supported on the port which has joined an aggregation group. Neither static
binding entries nor dynamic binding function can be configured on the port which has joined an
aggregation group.
Solution
Remove the port from the aggregation group.
MAC Address Lease
0001-0203-0406 86335
VLAN Interface
1 GigabitEthernet1/0/1
7-6