Creating An Rrpp Domain; Configuring Control Vlans; Configuring Protected Vlans; Configuring Rrpp Rings - 3Com 4510G Configuration Manual

Complete the following tasks to configure RRPP:

Creating an RRPP Domain

Configuring Control VLANs

Configuring Protected VLANs

Configuring
RRPP Rings
Activating an RRPP Domain
Configuring RRPP Timers
Configuring an RRPP Ring Group
RRPP does not have an auto election mechanism, so you must configure each node in the ring
network properly for RRPP to monitor and protect the ring network.
Before configuring RRPP, you need to construct a ring-shaped Ethernet topology physically.
Creating an RRPP Domain
When creating an RRPP domain, specify a domain ID, which uniquely identifies an RRPP domain. All
devices in the same RRPP domain must be configured with the same domain ID.
Make this configuration on devices you want to configure as nodes in the RRPP domain.
Follow these steps to create an RRPP domain:
To do...
Enter system view
Create an RRPP domain and
enter RRPP domain view
Task
Configuring RRPP Ports
Configuring RRPP Nodes
Use the command...
system-view
rrpp domain domain-id
Required
Perform this task on all nodes in the RRPP domain.
Required
Perform this task on all nodes in the RRPP domain.
Required
Perform this task on all nodes in the RRPP domain.
Required
Perform this task on all nodes in the RRPP domain.
Required
Perform this task on all nodes in the RRPP domain
Required
Perform this task on all nodes in the RRPP domain.
Optional
Perform this task on the master node in the RRPP
domain.
Optional
Perform this task on the edge node and
assistant-edge node in the RRPP domain.
3-10
Remarks
Remarks
—
Required