Configuring Selective Qinq Based On Ports; Configuring Selective Qinq Through Qos Policies - 3Com 4510G Configuration Manual

The two approaches can achieve the same result. If two approaches are both used to configure
different outer VLAN tagging policies on the same port, the outer VLAN tagging policy configured in the
QoS policy approach takes effect.

Configuring Selective QinQ Based on Ports

Switch 4510G series switches support the configuration of basic QinQ and selective QinQ at the same
time on a port and when the two features are both enabled on the port, frames that meet the selective
QinQ condition are handled with selective QinQ on this port first, and the left frames are handled with
basic QinQ.
Follow these steps to configure an outer VLAN tagging policy:
To do...
Enter system view
Enter interface
view or port
group view
Enter QinQ view and configure
the SVLAN tag for the port to
add
Tag frames of the specified
CVLANs with the current SVLAN
An inner VLAN tag corresponds to only one outer VLAN tag.
If you want to change an outer VLAN tag, you must delete the old outer VLAN tag configuration
and configure a new outer VLAN tag.

Configuring Selective QinQ through QoS Policies

The Switch 4510G series switches support configuring selective QinQ through QoS policies. To
implement adding outer VLAN tags according to inner VLAN tags, you can configure a class to match
packets with the specified inner VLAN tags, configure an outer VLAN tagging behavior, associate the
class with the behavior in a QoS policy, and then apply the QoS policy to the port connecting to users.
Follow these steps to configure an outer VLAN tagging policy though QoS policies:
To do...
Enter system view
Use the command...
system-view
Enter
Ethernet or
interface interface-type
Layer-2
interface-number
aggregate
interface view
Enter port
port-group manual
group view
port-group-name
qinq vid vlan-id
raw-vlan-id inbound { all |
vlan-list }
Use the command...
system-view
10-6
Remarks
—
Required
Use either command
Required
By default, the SVLAN tag to
be added is the default VLAN
tag of the receiving port.
Required
Remarks
—