Dual Stack Configuration; Dual Stack Overview; Configuring Dual Stack - 3Com 4510G Configuration Manual

14

Dual Stack Configuration

When configuring dual stack, go to these sections for information you are interested in:

Dual Stack Overview

Configuring Dual Stack

Dual Stack Overview
Dual stack is the most direct approach to making IPv6 nodes compatible with IPv4 nodes. The best
way for an IPv6 node to be compatible with an IPv4 node is to maintain a complete IPv4 stack. A
network node that supports both IPv4 and IPv6 is called a dual stack node. A dual stack node
configured with an IPv4 address and an IPv6 address can have both IPv4 and IPv6 packets
transmitted.
For an upper layer application supporting both IPv4 and IPv6, either TCP or UDP can be selected at
the transport layer, while IPv6 stack is preferred at the network layer.
Figure 14-1 illustrates the IPv4/IPv6 dual stack in relation to the IPv4 stack.
Figure 14-1 IPv4/IPv6 dual stack in relation to IPv4 stack (on Ethernet)
IPv4 application
TCP
IPv4
Protocol ID:
0x0800
Ethernet
IPv4 stack
Configuring Dual Stack
You must enable the IPv6 packet forwarding function before dual stack. Otherwise, the device cannot
forward IPv6 packets even if IPv6 addresses are configured for interfaces.
Follow these steps to configure dual stack on a gateway:
Enter system view
Enable the IPv6 packet forwarding function
IPv4/IPv6 application
UDP TCP
IPv4
Protocol ID:
0x0800
To do...
UDP
IPv6
Protocol ID:
0x86DD
Ethernet
Dual stack
Use the command...
system-view
ipv6
14-1
Remarks
—
Required
Disabled by
default.