Configuring Ripng Route Summarization; Advertising A Default Route - 3Com 4510G Configuration Manual

The inbound additional metric is added to the metric of a received route before the route is added into
the routing table, so the route's metric is changed.
Follow these steps to configure an inbound/outbound additional routing metric:
To do...
Enter system view
Enter interface view
Specify an inbound routing
additional metric
Specify an outbound routing
additional metric

Configuring RIPng Route Summarization

Follow these steps to configure RIPng route summarization:
To do...
Enter system view
Enter interface view
Advertise a summary IPv6
prefix

Advertising a Default Route

Follow these steps to advertise a default route:
To do...
Enter system view
Enter interface view
Advertise a default route
With this feature enabled, a default route is advertised through the specified interface regardless of
whether the default route is available in the local IPv6 routing table.
Use the command...
system-view
interface interface-type
interface-number
ripng metricin value
ripng metricout value
Use the command...
system-view
interface interface-type interface-number
ripng summary-address ipv6-address
prefix-length
Use the command...
system-view
interface interface-type
interface-number
ripng default-route { only |
originate } [ cost cost ]
5-5
Remarks
––
––
Optional
0 by default
Optional
1 by default
Remarks
––
––
Required
Remarks
––
––
Required
Not advertised by default