Creating A Hwtacacs Scheme; Specifying The Hwtacacs Authentication Servers - 3Com 4510G Configuration Manual

Creating a HWTACACS scheme

The HWTACACS protocol is configured on a per scheme basis. Before performing other HWTACACS
configurations, follow these steps to create a HWTACACS scheme and enter HWTACACS scheme
view:
To do...
Enter system view
Create a HWTACACS scheme and
enter HWTACACS scheme view
Up to 16 HWTACACS schemes can be configured.
A scheme can be deleted only when it is not referenced.

Specifying the HWTACACS Authentication Servers

Follow these steps to specify the HWTACACS authentication servers:
To do...
Enter system view
Create a HWTACACS scheme
and enter HWTACACS
scheme view
Specify the primary
HWTACACS authentication
server
Specify the secondary
HWTACACS authentication
server
It is recommended to specify only the primary HWTACACS authentication server if backup is not
required.
If both the primary and secondary authentication servers are specified, the secondary one is used
when the primary one is not reachable.
The IP addresses of the primary and secondary authentication servers cannot be the same.
Otherwise, the configuration fails.
You can remove an authentication server only when no active TCP connection for sending
authentication packets is using it.
Use the command...
system-view
hwtacacs scheme
hwtacacs-scheme-name
Use the command...
system-view
hwtacacs scheme
hwtacacs-scheme-name
primary authentication
ip-address [ port-number ]
secondary authentication
ip-address [ port-number ]
1-31
Remarks
—
Required
Not defined by default
Remarks
—
Required
Not defined by default
Required
Configure at least one of the
commands
No authentication server by
default