Displaying Web Users - 3Com 4510G Configuration Manual

To do...
Configure the authorization
attributes for the local user
Specify the service types for
the local user

Displaying Web Users

After the above configurations, execute the display command in any view to display the information
about Web users, and thus to verify the configuration effect.
Table 5-2 Display information about Web users
Display information about Web users
Configuration Example
Step 1: Log in to the switch through the console port and assign an IP address to the management
VLAN interface of the switch. By default, VLAN 1 is the management VLAN.
Connect to the console port. Refer to section
Execute the following commands in the terminal window to assign an IP address to the
management VLAN interface of the switch.
# Configure the IP address of the management VLAN interface to be 10.153.17.82 with the mask
255.255.255.0.
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] ip address 10.153.17.82 255.255.255.0
Step 2: Configure the user name and the password for the Web-based network management system.
# Configure the user name to be admin.
[Sysname] local-user admin
# Set the password to admin.
[Sysname-luser-admin] password simple admin
Step 3: Establish an HTTP connection between your PC and the switch, as shown in the following
figure.
Figure 5-1 Establish an HTTP connection between your PC and the switch
Use the command...
authorization-attribute level
level
service-type telnet
To do...
5-2
Optional
By default, no authorization
attribute is configured for a
local user.
Optional
By default, no service is
authorized to a user.
Use the command...
display web users
Setting Up the Connection to the Console
Remarks
Port.