To Configure the Remote Interface - 34970A
The 34970A is shipped with both an GPIB (IEEE-488) interface and an
RS-232 interface. Only one interface can be enabled at a time. The GPIB
interface is selected when the instrument is shipped from the factory.
GPIB Configuration
1 Select the GPIB interface.
GPIB / 488
2 Select the GPIB address.
You can set the instrument's address to any value between 0 and 30. The
factory setting is address "9".
ADDRESS 09
3 Save the change and exit the menu.
Note: Your computer's GPIB interface card has its own address. Be sure
to avoid using the computer's address for any instrument on the interface
bus. Agilent's GPIB interface cards generally use address "21".
Chapter 2 Front-Panel Overview
To Configure the Remote Interface - 34970A
2
4
53