Chapter 2 Front-Panel Overview
To Configure the Remote Interface
To Configure the Remote Interface
The instrument is shipped with both an GPIB ( IEEE -488) interface
and an RS -232 interface. Only one interface can be enabled at a time.
The GPIB interface is selected when the instrument is shipped from
the factory.
GPIB Configuration
1 Select the GPIB (HPIB) interface.
HPIB / 488
2 Select the GPIB address.
Interface
You can set the instrument's address to any value between 0 and 30.
The factory setting is address "9".
ADDRESS 09
3 Save the change and exit the menu.
Interface
Note: Your computer's GPIB interface card has its own address.
Be sure to avoid using the computer's address for any instrument on the
interface bus. Agilent's GPIB interface cards generally use address "21".
46
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com