To Set A Scan Interval - Agilent Technologies 34972A User Manual

To Set a Scan Interval

You can set the instrument's internal timer to automatically scan at a
specific interval (e.g., start a new scan sweep every 10 seconds) or when
an external TTL trigger pulse is received. You can configure the
instrument to scan continuously or to stop after sweeping through the
scan list a specified number of times.
1 Select the interval scan mode.
For this example, select the Interval Scan mode which allows you to set
the time from the start of one scan sweep to the start of the next scan
sweep. Set the interval to any value between 0 and 99 hours
.
INTERVAL SCAN
2 Select the scan count.
You can specify the number of times that the instrument will sweep
through the scan list (the default is continuous). When the specified
number of sweeps have occurred, the scan stops. Set the scan count to
any number between 1 and 50,000 scans (or continuous).
00020 SCANS
3 Run the scan and store the readings in memory.
Chapter 2 Front-Panel Overview

To Set a Scan Interval

2
4
45