Agilent Technologies 34972A User Manual page 147

• Remote Interface Operation: To clear the specified output lines (or to
clear all four lines), use one of the following commands.
OUTPUT:ALARM2:CLEAR
OUTPUT:ALARM:CLEAR:ALL
To select the output configuration for all four output lines, use the
following command.
OUTPut:ALARm:MODE {LATCh|TRACk}
To configure the slope of all four output lines, use the following
command.
OUTPut:ALARm:SLOPe {NEGative|POSitive}
Chapter 4 Features and Functions
Clear alarm output line 2
Clear all four alarm outputs
Alarm Limits
4
147