Agilent Technologies 34972A User Manual page 161

• You can assign a name to the storage locations (you cannot assign a
name to location "0"). You can name a location from the front panel or
over the remote interface but you can only recall a named state from
the front panel. From the remote interface, you can only recall a
stored state using a number (0 through 5).
• The name can contain up to 12 characters. The first character must
be a letter (A-Z), but the remaining 11 characters can be letters,
numbers (0-9), or the underscore character (" _ "). Blank spaces are
not allowed. An error is generated if you specify a name with more
than 12 characters.
• A Factory Reset (*RST command) does not affect the configurations
stored in memory. Once a state is stored, it remains until it is
overwritten or specifically deleted.
• Front-Panel Operation:
NAME STATE , STORE STATE , RECALL STATE
After recalling a stored state, you will notice that a new choice
(UNDO RECALL) is added under RECALL STATE. This allows you to
cancel the last recall operation and revert to the previous state. You
can also select LAST PWR DOWN to recall the state of the instrument
at the power-down.
To configure the instrument to recall the power-down state or issue a
Factory Reset when power is restored, select from the following.
PWR ON LAST , PWR ON RESET
• Remote Interface Operation: Use the following commands to store and
recall instrument states (state "0" is the state of the instrument at
power down).
*SAV {0|1|2|3|4|5}
*RCL {0|1|2|3|4|5}
Chapter 4 Features and Functions
System-Related Operations
4
161