Plug-In Module Errors
NOTE: The following error messages indicate possible hardware
failures within the instrument. If any of the following errors occur,
contact your nearest Agilent Service Center for repair.
Module hardware: unexpected data received
901
Module hardware: missing stop bit
902
Module hardware: data overrun
903
Module hardware: protocol violation
904
Module hardware: early end of data
905
Module hardware: missing end of data
906
Module hardware: module srq signal stuck low
907
Module hardware: not responding
908
Module reported an unknown module type
910
Module reported command buffer overflow
911
Module reported command syntax error
912
Module reported nonvolatile memory fault
913
Module reported temperature sensor fault
914
Module reported firmware defect
915
Module reported incorrect firmware installed
916
Chapter 5 Error Messages
Plug-In Module Errors
4
5
239