TracVision M5/M7 User's Guide
Appendix B - Recalibration
Step 1 - Clear the Existing Calibration Score
88
Use the flowchart in Figure B-1 to clear the existing calibration score.
NOTE: If the "System Halted Power System Off/On" message is displayed
during this procedure, turn the system off, wait 10 seconds, then turn the
system on. Wait one minute for initialization before restarting the procedure.
NOTE: Be sure to turn the system off after completing this procedure. Wait
10 seconds, then turn the system on.
Figure B-1 Clearing the Existing Calibration Score
<Default Display>
Menu
Setup display type?
Enter
Next Return
Select Next
until "Control
compass?" is
displayed.
Control compass?
Enter Next
Return
Then select "Yes" to
confirm your selection.
Set AutoCal On/Off?
Yes
Next
Return
Select Next
until "Clear
COMPASS
Cal?" is
displayed.
Clear COMPASS Cal?
Yes
Next
Return
Then select "Yes" to
confirm your selection.
AutoCal resetting
Please wait
AutoCal reset done
Turn system Off/On