Setting Instant On Mode
When Instant On mode is enabled, the antenna can immediately
receive signals on startup if the vessel has not moved since the antenna
was last shut off. However, if the system is turned off, then the vessel
moves after last acquiring the satellite via Instant On, the antenna will
undergo its standard initialization process once it is turned back on,
resulting in a brief delay.
NOTE: Instant On is disabled by default and is not recommended for DISH
Network or ExpressVu configurations.
Use the flowchart in Figure 3-24 if you wish to enable Instant On
mode, or if you wish to restore the original setting.
Figure 3-24 Enabling/Disabling Instant On Mode
<Default Display>
Setup display type?
Enter
Control antenna?
Enter Next
Then select "Yes" to
confirm your selection.
Man control antenna?
Yes
Set instant on/off?
Yes
INSTANT mode: OFF
On
Select On or Off as required,
then select Enter.
Menu
Next Return
Select Next
until "Control
antenna?"
is displayed.
Return
Next
Return
Select Next
until "Set
instant on/off?"
is displayed.
Next
Return
Enter
Off
TracVision M5/M7 User's Guide
Chapter 3 - Settings
55