TracVision M5/M7 User's Guide
Chapter 2 - Operation
Automatic Satellite Switching
22
Most TracVision systems switch between satellites automatically
while you change channels using the primary receiver's remote
control. The primary receiver is the receiver connected to the antenna's
RF1 cable (see Figure 2-15 and Figure 2-16). If an optional secondary
receiver is connected, you can use its remote control to switch between
the channels on the currently selected satellite.
Figure 2-15 Primary/Secondary Receiver Control (Dual-output version shown)
Antenna
RF2
RF1
RF2
Changes
channels on
current satellite
Figure 2-16 Automatically Switching Between Satellites - ADCU Display
Three Satellites Installed
Tracking <Sat A>
<Sat B> Menu <Sat C>
Available Satellites
(Buttons Not Used)
Selected
Satellite
ADCU
Grounding Block
(Sky Mexico Systems Only)
Primary Receiver
RF1
Secondary
Receiver
satellites/channels
(optional)
Two Satellites Installed
Tracking <Sat A>
OR
<Sat B> Menu
Available Satellite
(Button Not Used)
GyroTrac Sensor
Automatically
switches
Selected
Satellite