TracVision M5/M7 User's Guide
Chapter 2 - Operation
Turning the System On/Off
Turning On the System
Turning Off the System
14
Since power to the TracVision system is controlled by the vessel
power, you can turn the system on or off by applying/removing vessel
power.
Follow the steps below to turn on your TracVision system.
IMPORTANT!
Avoid turning the vessel or changing channels for one minute
after turning on the system.
1. Make sure the antenna has a clear view of the sky.
2. Turn on your satellite TV receiver and TV.
3. If a GPS is connected, ensure the GPS receiver has
obtained an accurate position.
4. Apply operating power to the TracVision system.
TIP: When operating power is applied to the ADCU, the ADCU initiates a
startup sequence. The LCD updates as diagnostic tests are performed.
5. Wait one minute for system startup.The ADCU will
display the Tracking Satellite screen after system self
testing is complete.
Figure 2-3 Tracking Satellite Screen
Tracking <Sat A>
<Sat B> Menu <Sat C>
Available Satellites
Selected
Satellite
Follow the steps below to turn off your TracVision system.
1. Remove operating power from the TracVision system.
2. Turn off your satellite TV receiver and TV.