KVH Industries TracVision M5 User Manual page 23

Dual-Sat Automatic Mode - Preferred Mode for One or Two Receivers*
The antenna switches between satellites automatically while you
change channels using the primary receiver's remote control. The
primary receiver is the receiver connected to the antenna's RF1 cable
(see Figure 2-11 and Figure 2-12). If an optional secondary receiver is
connected, you can use its remote control to switch between the
channels on the currently selected satellite.
*NOTE: Custom Dual-Sat configurations must use Manual mode.
Figure 2-11 Dual-Sat Automatic Mode - Receiver Controls
Antenna
RF2 RF1
RF2
Changes
channels on
current satellite
Figure 2-12 Dual-Sat Automatic Mode - ADCU Display
Tracking <Sat A>
<Sat B> Menu
Available Satellite
(Button Not Used)
ADCU
Grounding
Primary Receiver
Block
RF1
Secondary
Receiver
satellites/channels
(optional)
Selected
Satellite
TracVision M5/M7 User's Guide
Chapter 2 - Operation
GyroTrac Sensor
Automatically
switches
19