KVH Industries TracVision M5 User Manual page 29

DISH Network/ExpressVu Receiver Configuration
If your TracVision M5/M7 system is set up for DISH Network or
ExpressVu service, your receiver(s) should have also been configured
during installation. In most cases, you do not need to reconfigure your
receiver(s). However, Figure 2-20 lists special scenarios that require
DISH Network/ExpressVu receiver configuration.
Figure 2-20 Receiver Configuration Requirements
Receiver Configuration is Required When...
• DISH 1000 only - You change satellite coverage
areas (see Figure 2-5 on page 15)
• You add a receiver
• You have reconfigured a receiver for home use
If you need to configure a receiver(s) for DISH Network/ExpressVu
service, follow the instructions for your selected service type in
Chapter 3, "Settings" on page 31.
Linear Receiver Configuration
If the TracVision system does not include a multiswitch, you can
configure the receiver(s) to enable automatic satellite switching.
TracVision systems with a multiswitch installed require switching
satellites manually using the ADCU, which does not require receiver
configuration.
To configure the receivers for automatic switching, set up the satellites
in the receiver in the same order they were set up in the TracVision
system (see Figure 2-21).
Figure 2-21 Antenna/Receiver Synchronization Settings
TracVision Satellite
Satellite A
Satellite B
Satellite C*
*NOTE: Only European Tri-Sat configurations track three satellites.
Receiver Satellite DiSEqC Setting
Alternative 1 or A DiSEqC 1
Alternative 2 or B DiSEqC 2
Alternative 3 or C DiSEqC 3
TracVision M5/M7 User's Guide
Chapter 2 - Operation
25