Recalibrating The System - KVH Industries TracVision M5 User Manual

Recalibrating the System

During installation, the TracVision M5/M7 system should have been
properly calibrated. However, if the GyroTrac sensor is moved to
another location, or if additional metallic equipment is installed or
removed near the GyroTrac sensor, KVH recommends recalibrating
the system. This section explains how to recalibrate the system.
To perform this procedure, you will need to perform the following:
• Clear the existing calibration score
• Turn on autocalibration
• Recalibrate the system
• Verify the calibration score
• Turn off autocalibration
IMPORTANT!
If the system is currently configured to use an external compass,
you must set the TracVision system to use an internal heading
reference before performing this procedure. See "Setting the
Heading Reference Source" on page 77 for more information.
TracVision M5/M7 User's Guide
Appendix B - Recalibration
87