Configuring Ap-To-Switch Authentication Information; Configuring Vlan Information On The Access Point; Table 5: Ieee 802.1X Supplicant Commands - D-Link DWS-3000 Series User Manual

Software User Manual
02/15/2011
Table 5 shows the commands you can use to configure 802.1X supplicant information.
Action
View 802.1X supplicant settings
Enable 802.1X supplicant
Disable 802.1X supplicant
Set the 802.1X user name
Set the 802.1s password
In the following example, the administrator enables the 802.1X supplicant and sets the user name to wlanAP and the
password to test1234.
WLAN-AP# set dot1x-supplicant status up
WLAN-AP# set dot1x-supplicant user wlanAP
WLAN-AP# set dot1x-supplicant password test1234
WLAN-AP# get dot1x-supplicant
Property Value
----------------
status up
user wlanAP

Configuring AP-to-Switch Authentication Information

You can configure a pass phrase on the AP and on the switch so that only authenticated APs can associate with the switch.
If you do enable AP authentication on the Unified Switch, you must connect to the access point CLI and configure a pass
phrase. This pass phrase must be the same as the one you configure on the Unified Switch.
To configure the pass phrase on the AP, use the following command:
set managed-ap pass-phrase <phrase>
The pass phrase can be up to 32 alphanumeric characters.
For example, the following command sets the AP-to-Unified Switch authentication pass phrase to test1234.
WLAN-AP# set managed-ap pass-phrase test1234
For more information about AP-to-Unified Switch authentication and how to configure it on the switch, see
Authentication" on page 71.

Configuring VLAN Information on the Access Point

The management VLAN is VLAN 1 by default. This VLAN is also the default untagged VLAN. This means that all traffic,
including management traffic, is untagged.
If you want to limit access to the management interface on the access point or if you already have a management VLAN
configured on your network with a different VLAN ID, you can change the VLAN ID of the management VLAN on the access
point from the AP CLI.
Document 34CS3000-SWUM104-D10

Table 5: IEEE 802.1X Supplicant Commands

Command
get dot1x-supplicant
set dot1x-supplicant status up
set dot1x-supplicant status down
set dot1x-supplicant user <name>
set dot1x-supplicant password <password>
D-Link Unified Access System
"Configuring AP
Page 57