Installing The Switch Without The Rack; Installing The Switch In A Rack; Figure 19: Prepare Switch For Installation On A Desktop Or Shelf; Figure 20: Fasten Mounting Brackets To Switch - D-Link DWS-3000 Series User Manual

D-Link Unified Access System
• The power outlet should be within 1.82 meters (6 feet) of the Switch.
• Visually inspect the power cord and see that it is fully secured to the AC power port.
• Make sure that there is proper heat dissipation from the Switch and adequate ventilation around the Switch. Leave at
least 10 cm (4 inches) of space at the front and rear of the Switch for ventilation.
• Install the Switch in a fairly cool and dry place for the acceptable temperature and humidity operating ranges.
• Install the Switch in a site free from strong electromagnetic field generators (such as motors), vibration, dust, and direct
exposure to sunlight.
• When installing the Switch on a level surface, attach the rubber feet to the bottom of the device. The rubber feet cushion
the Switch, protect the casing from scratches, and prevent it from scratching other surfaces.

Installing the Switch without the Rack

First, attach the rubber feet included with the Switch if installing on a desktop or shelf. Attach these cushioning feet on the
bottom at each corner of the device. Allow enough ventilation space between the Switch and any other objects in the vicinity.
Rubber Feet

Installing the Switch in a Rack

The Switch can be mounted in a standard 19" rack. Use the following diagrams as a guide.
Page 44

Figure 19: Prepare Switch for Installation on a Desktop or Shelf

Figure 20: Fasten Mounting Brackets to Switch

Software User Manual
02/15/2011
Document 34CS3000-SWUM104-D10