Creating The Vlan Routing Interface - D-Link DWS-3000 Series User Manual

Software User Manual
02/15/2011
The network must have routes between the Unified Switch and the APs to manage. The APs must be able to ping the IP
address of the loopback interface used as the WLAN interface on the Unified Switch.
The following procedures show an example of how to enable routing and configure an IP address on a loopback or routing
interface.
1 Log on to the CLI and switch to Global Config mode:
(System-Prompt)
User: admin
Password:
(System-Prompt) >enable
Password:
(System-Prompt) #config
(System-Prompt) (Config)#
2 Enable routing.
(System-Prompt) (Config)#ip routing
3 Change to Interface Config mode for loopback interface 0, and assign an IP address and subnet mask.
(System-Prompt) (Config)#interface loopback 0
(System-Prompt) (Interface loopback 0)#ip address 192.168.100.15 255.255.255.255
You can also use the Web interface or SNMP to enable routing and configure an IP address. The following example shows
the procedures to enable routing and configure an IP address on the switch by using the Web interface.
1 Log on to the Web interface and click Routing > IP > Configuration to access the IP Configuration page.
2 From the Routing Mode menu, choose Enable, and then click Submit.
3 To create a loopback interface, click Routing > Loopback > Configuration.
4 From the Loopback menu, choose Create, and then click Submit
5 Enter an IPv4 address and subnet mask in the appropriate fields, and then click Submit.

Creating the VLAN Routing Interface

The D-Link Unified Switch and the D-Link Access Point support Virtual LANs (VLANs) to provide the logical separation of a
physical network. You can use VLANs to segment the wireless network on a per-VAP basis. VLAN routing interfaces allow
VLANs to span across different subnets, which is useful for L3 Tunneling.
In <Link>Figure 109, WS1 and WS2 have a VLAN routing interface on the L3 Tunnel subnet. The following commands show
how to configure the interface for WS1, which has a VLAN Routing interface with VLAN ID 200 and an IP address of
192.168.60.15.
1 Enter VLAN config mode, create a VLAN, and give it a name.
(switch-prompt) #vlan database
(switch-prompt) (Vlan)#vlan 200
(switch-prompt) (Vlan)#vlan name 200 "L3 Tunnel"
2 Create a VLAN routing interface on VLAN 200.
(switch-prompt) (Vlan)#vlan routing 200
3 Exit to Privileged EXEC mode and view the VLAN routing interface configuration.
(switch-prompt) (Vlan)#exit
(switch-prompt) #show ip vlan
Document 34CS3000-SWUM104-D10
D-Link Unified Access System
Page 215