Adjusting The Channel And Power; Table 26: Managed Ap Channel/Power Adjust - D-Link DWS-3000 Series User Manual

D-Link Unified Access System
Field
Enable Debug
Use the buttons at the bottom of the page to perform the following tasks:
• Click Cancel to cancel changes you typed in the fields on this page.
• Click Apply to apply changes you typed in the fields on this page.

Adjusting the Channel and Power

Changes you make to the channel and power are runtime changes only. If you change the channel or power settings, the
new settings are lost if the AP or switch is reset.
The fields in <Link>Table 26 appear when you click the current channel or power setting for an AP on the Managed AP
Advanced page.
Field
AP MAC Address
Radio
Channel Status
Page 116
Table 25: AP Debug
Description
Select or clear the Enable check box to enable or disable debugging.
Once once you Telnet to the AP, you get an AP interface login prompt. The user name is
admin. Enter the password you set in the previous field. The default password is admin if you
did not specify a new password. From the AP CLI, you can also access the standard Linux
prompt by typing the '!' character.
You can issue the following debug commands at the Linux OS prompt:
• get management—Display management interface information
• get managed-ap—Display managed AP information
You can issue the following debug commands at the Linux OS prompt:
• ifconfig—display all interfaces.
• cat /proc/meminfo—View memory utilization

Table 26: Managed AP Channel/Power Adjust

Description
Shows the MAC address of the access point.
Displays the radio and its mode. The changes apply only to this radio.
The status is one of the following:
• None
• Set Requested
• Set Complete
Software User Manual
02/15/2011
Document 34CS3000-SWUM104-D10