Viewing The Channel Plan History; Figure 51: Channel Plan History - D-Link DWS-3000 Series User Manual

D-Link Unified Access System
Field
Channel Plan
Interval
Channel Plan Fixed
Time
Power Adjustment
Mode
Power Adjustment
Interval
Click Submit to update the switch with the values on the screen. If you want the switch to retain the new values across a
power cycle you must perform a save.

Viewing the Channel Plan History

The D-Link Unified Switch stores channel assignment information for the APs it manages. To access the Channel Plan
History information, click the AP Management > RF Management > Channel Plan History tab.
Page 108
Table 20: RF Channel Plan and Power Adjustment
Description
If you select the Interval channel plan mode, you can specify the frequency at which the
channel plan calculation and assignment occurs. The interval time is in hours, and you can
specify an interval that ranges between every 6 hours to every 24 hours.
If you select the Fixed Time channel plan mode, you can specify the time at which the channel
plan calculation and assignment occurs. The channel plan calculation will occur once every
24 hours at the time you specify.
You can set the power of the AP radio frequency transmission in the AP profile, the local
database or in the RADIUS server. The power level in the AP profile is the default level for the
AP, and the power will not be adjusted below the value in the AP profile.
The settings in the local database and RADIUS server always override power set in the profile
setting. If you manually set the power, the level is fixed and the AP will not use the automatic
power adjustment algorithm.
You can configure the power as a percentage of maximum power, where the maximum power
is the minimum of power level allowed for the channel by the regulatory domain or the
hardware capability.
• Manual—In this mode, you run the proposed power adjustments manually from the Manual
Power Adjustments page.
• Interval—In this mode, the switch periodically calculates the power adjustments and applies
the power for all APs. The interval period begins when you click Submit.
Note: If you set the power level in the local or RADIUS database, the settings override the
power level set in the AP profile.
For more information about manually setting the power level, see
Settings" on page 81 and
This field determines how often the switch runs the power adjustment algorithm. The algorithm
runs automatically only if you set the power adjustment mode to Interval.

Figure 51: Channel Plan History

"Configuring Valid Access Point Settings" on page
Software User Manual
02/15/2011
"Configuring Wireless Radio
101.
Document 34CS3000-SWUM104-D10