Configuring The Dhcp Server - D-Link DWS-3000 Series User Manual

D-Link Unified Access System

Configuring the DHCP Server

To configure DHCP on the D-Link Unified Switch, you configure the global DHCP settings and the address pool for the
clients. The following example shows how to create an address pool for the wireless clients on the L3 Tunnel network. You
can create additional address pools so that the DHCP server on the Unified Switch can serve IP addresses to wireless clients
that use other networks (such as the Guest Network or Corporate LAN).
The following commands show how to configure a DHCP server to use for the wireless clients that connect to the L3 Tunnel
wireless network.
1 From Global Config mode, enable DHCP.
(switch-prompt) (Config)#service dhcp
2 Exclude the IP addresses in the range of 192.168.60.1 through 192.168.60.50, which includes the IP addresses of WS1,
WS2, and the Call Server.
(switch-prompt) (Config)#ip dhcp excluded-address 192.168.2.201 192.168.2.255
3 Create an address pool.
(switch-prompt) (Config)#ip dhcp pool vlan200
4 Configure the L3 Tunnel subnet and netmask as the network address for the clients on VLAN 200.
(switch-prompt) (Config)network 192.168.60.0 255.255.255.0
5 Configure the default router for the address pool.
(switch-prompt) (Config)default-router 192.168.60.1
Use the following procedures to perform the same configuration by using the Web interface.
1 From the Administration > DHCP Server > Global Configuration page, enable the Admin Mode and enter the range
of IP addresses that you do not want to assign to wireless clients, then click Submit.
2 Navigate to the Administration > DHCP Server > Pool Configuration page and select Create from the Pool Name
menu.
3 Enter a name for the address pool in the Pool Name field and select Dynamic from the Type of Binding menu.
4 Enter a network number, network mask, and default router address in the appropriate fields and click Submit.
Page 224
Software User Manual
02/15/2011
Document 34CS3000-SWUM104-D10