Figure 48: Configuring A Valid Ap; Table 19: Valid Ap Configuration - D-Link DWS-3000 Series User Manual

Software User Manual
02/15/2011
Acknowledged Rogue and assign an AP profile to the device. When the switch collects and reports information from the RF
scan, it can assign the appropriate status to an AP if it is in the database.
Click on the MAC Address to navigate to the Valid Access Point Configuration page.
<Link>Table 19 describes the fields available on the Valid Access Point Configuration page.
Field
MAC Address
Managed Mode
Location
Authentication
Password
Profile
Document 34CS3000-SWUM104-D10

Figure 48: Configuring a Valid AP

Table 19: Valid AP Configuration

Description
This field shows the MAC address of the AP. To change this field, you must delete the entire
Valid AP configuration and then enter the correct MAC address from the page that lists all
Valid APs.
You can configure the D-Link Access Point to be in one of three modes:
• Standalone—The AP acts as an individual access point in the network. You do not manage
the AP by using the switch. Instead, you log on to the AP itself and manage it by using the
Administrator Web User Interface (UI) or CLI.
• WS Managed—The AP is part of the D-Link Unified Access System, and you manage it by
using the D-Link Unified Switch. If an AP is in Managed Mode, the Administrator Web UI on
the AP are disabled.
• Acknowledged Rogue—The AP has been discovered by the switch and acknowledge as a
Rogue. This AP is not a D-Link Access Point. You can add an Acknowledged Rogue to the
Valid AP list to prevent the Rogue from being identified as a threat.
To help you identify the AP, you can enter a location. This field accepts up to 32 alphanumeric
characters.
You can require the AP to authenticate itself with the switch upon discovery. If you require
authentication, which is a setting on the Basic Setup > Global tab, you enter the password
in this field. The password in this field must match the password configured on the AP.
If you configure multiple AP Profiles, you can select the profile to assign to this AP. For more
information about configuring AP Profiles, see
Profiles" on page 153.
D-Link Unified Access System
"Creating, Configuring, and Managing AP
Page 103