Configuring Dhcp Relay And The Dhcp Server; Configuring The Relay Agent - D-Link DWS-3000 Series User Manual

Software User Manual
02/15/2011
When you update the profile, the Unified Switch adds the L3 Tunnel network to the Managed APs that use the default profile.
C DHCP R
ONFIGURING
Unless you use the Unified Switch as a DHCP server or use static IP addresses for all devices, you must enable DHCP relay
on the switch so that the switch can forward DHCP requests from the roaming wireless clients to the DHCP server on your
network.
If you choose to use the Unified Switch as a DHCP server for wireless clients, you must configure the DHCP server and the
address pool for wireless clients.

Configuring the Relay Agent

Use the following command in Global Config mode to enable BootP and DHCP relay on the switch:
bootpdhcprelay enable
Use the following command in Global Config mode to specify the IP address of the BootP or DHCP server that will assign
IP addresses to wireless clients:
bootpdhcprelay serverip 192.168.30.2
To configure BootP and DHCP relay from the Web interface on the switch, go to the L3 Features > BootP/DHCP Relay
Agent > Configuration page. Configure the server IP address and enable the Admin Mode, then click Submit.
Document 34CS3000-SWUM104-D10
DHCP S
ELAY AND THE
D-Link Unified Access System
ERVER
Page 223