Table of Contents
Advertisement
SECTION 4: ASSEMBLY
Bench Mounting
The Model G5045 can be mounted on a work-
bench or a portable stand, in addition to its stan-
dard heavy-duty base. If the saw is bench-mount-
ed, it is essential to create a cutout below the saw
to allow sawdust to exit the machine. The cutout
should measure 11" to 12" square and should be
centered underneath the saw's frame. For maxi-
mum stability, the saw should be secured to the
bench with
3
⁄
" lag bolts or
8
Stand Assembly
The G1022/G1022Z Table Saw is supplied with a
heavy-duty stamped steel stand. To assemble
the stand:
1. Fasten the plastic feet to all four legs using
the M10 - 1.5 x 25mm Hex Bolts, 10mm
Flat washers and M10 - 1.5 Hex Nuts sup-
plied. See Figure 2.
Figure 2. Attaching feet to stand.
G5045 10'' Bench Top Table Saw
3
⁄
" through bolts.
8
2. Locate the long upper and lower side
braces (2 each) and bolt to the legs using
the M8-1.25 x 16mm Carriage Bolts, 8mm
Flat Washers and M8-1.25 Hex Nuts
Supplied. See Figure 3. Do not tighten any
stand bolts until Step 5. Finger tighten only
for now.
Figure 3. Assembled side panel.
Some die-cut metal parts may have sharp
edges (called "flashing") on them after they
are formed. Please examine the edges of
all die-cut metal parts before handling
them. Failure to do so could result in injury.
-9-
Advertisement
Table of Contents
