Table of Contents
Advertisement
Handwheels
To mount the handwheels:
1. Position a handwheel over the arbor raising
shaft on the front of the saw. Be sure it fits
completely over the shaft. The slots in the
handwheel hole will engage with the roll pin
on the shaft. See Figure 7.
2. Position the other handwheel similarly on
the blade tilting shaft on the side of the saw.
3. Screw the black plastic lock knobs onto the
ends of the shafts to lock the handwheels in
place.
Figure 7. Installing handwheel.
Rip Fence
The rip fence provides a guide which keeps your
workpiece aligned parallel to the saw blade. To
mount the rip fence:
1. Attach the fence locking lever by threading
it into the eccentric located at the front of
the fence. See Figure 8.
G5045 10'' Bench Top Table Saw
Figure 8. Attaching fence locking handle.
2. Lift the fence over the saw's table top,
ensuring that the rear holding clamp fits
over the rear rail. See Figure 9.
Figure 9. Attaching fence to saw table.
3. After fitting the rear holding clamp on the
rear rail, lower the front of the fence onto
the front rail. Once the fence is on the table,
push down the fence locking handle to
secure the fence in place. If the fence is not
solidly secured, or if the locking handle can-
not be depressed, some adjustment may be
required. We will address that process in
the Adjustment Section of the manual.
-11-
Advertisement
Table of Contents
