Table of Contents
Advertisement
Estimated Assembly Time: 25 - 40 Minutes.
INSTALLING THE STAND (FIG. A)
1. Unpack all parts and group by type and size.
Refer to the table of loose parts list on Page 11
for correct quantities.
2. Bag "F" & "H" - Attach one leg of front bracket
- upper support (1) to top of leg, marked "F" (2)
using one bolt (3) and nut (4). The stand leg is
placed on the outside of the brackets.
NOTE:
●
The left side of the bracket has only one hole
and the right side has two holes.
●
Only hand tighten at this point. Do not tighten
bolts with a wrench until stand is properly
aligned (see Step 8 before tightening).
The front and rear stand legs are different in
angles and cannot be mixed. The two front
stand legs are marked with an "F" and the two
rear stand legs are marked with an "R".
3. Attach other end of front bracket - upper support
(1) to top of other front leg (2) using two bolts (3)
and nuts (4).
4. Attach the front bracket - lower support (5) to
center of the two legs using bolt (3) and nut (4).
This completes the front frame section.
5. Bag "E" & "I" - Assemble rear frame section in
exactly the same manner using the shorter rear
brackets (13 & 14).
6. Bag "C" & "D" - Join the front and rear frame
sections using two brackets-upper supports (6)
and two lower supports (7) with bolts and nuts.
7. Bag "G" - Place the four foot pads (8) into the
bottom of each leg, lightly use a rubber mallet if
needed.
NOTE: The foot pads for the front stand legs and
the rear stand legs are different and cannot be
mixed. The two larger foot pads are marked (F)
and must be placed on the front stand legs. The
two smaller foot pads are marked (R) and must
be placed on the rear stand legs.
8. Place the stand on level surface, adjust all legs
to contact and at similar angles to the floor.
Tighten all bolts.
NOTE: To avoid rocking, all bolts must be
tightened securely using a 13 mm or adjustable
wrench.
-12-
Assembly
Fig. A
2(R)
8(R)
WARNING
!
● The stand is designed only for use with a
scroll saw.
● Do not climb, sit or stand on the stand
assembly.
● Do not use the stand on uneven or
unstable surface.
● To avoid injury, do not connect this
scroll saw to the power source until it
is completely assembled and adjusted
and you have read and understood this
instruction manual.
MOUNTING THE SCROLL SAW (FIG. B)
1. To mount your scroll saw to the stand, position
the assembled stand on a firm, level surface.
2. Line up the four holes (15) on the scroll saw base
with the holes in the stand leg, place the scroll
saw on the stand as shown below.
3. Secure the saw to the two mounting holes in the
front of the stand using two hex bolts (9), two flat
washers (10), two sleeves (11), and two nuts (12)
provided.
4. Secure the saw to the two mounting holes in the
rear of the stand using the two hex bolts (9), two
flat washers (10) and two nuts (12) provided.
NOTE: No sleeves (11) are used for rear two
mounting holes.
5. Tighten all four nuts using two 13 mm or
adjustable wrenches.
NOTE: Do not over tighten nuts, it may damage
the saw base.
9
10
13
14
12
11
4
1
6
3
5
7
2(F)
Front Side of
8(F)
Frame Assembly
Model G0938 (Mfd. Since 02/21)
Advertisement
Table of Contents
