Table of Contents
Advertisement
SECTION 8: MAINTENANCE
General
Make a habit of inspecting your saw each time
you use it. Check for the following conditions and
repair or replace when necessary.
1. Loose mounting bolts.
2. Worn switch.
3. Worn or damaged cords and plugs.
4. Dull or damaged blade.
5. Poor fence adjustment.
6. Poor blade adjustment.
7. Any other condition that could hamper the
safe operation of this machine.
Lubrication
Shielded and pre-lubricated ball bearings require
no lubrication for the life of the bearings. In a con-
tinuous-use environment, expect the bearings to
last for several years. With intermittent use, bear-
ings can be expected to last much longer. All
bearings are standard sizes and can be easily
replaced.
As for the rest of the machine, greasing the rack
and pinion is all that's necessary to keep it in top
working condition. Before applying, however,
wipe off any sawdust with a cloth or towel.
G5045 10'' Bench Top Table Saw
Unpainted Surfaces
Any non-painted surfaces on the Model G5045
should be protected against rust and pitting.
Wiping the saw clean after every use ensures
that moisture from sawdust isn't allowed to trap
moisture against bare metal surfaces.
Some woodworkers recommend using automo-
tive paste wax on exposed steel and cast iron
surfaces. The wax provides a layer of protection,
as well as reducing friction between lumber and
the table, making cuts faster and smoother. Avoid
waxes that contain silicone or other synthetic
ingredients. These materials can find their way
into lumber that's being cut, and can make stain-
ing and finishing difficult. If you use paste wax,
make sure that it's 100% Carnauba wax.
-23-
Advertisement
Table of Contents
