Assembly - Grizzly G9743 Owner's Manual

Assembly

The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
To assemble machine:
1.
Remove hex bolt and flat washer shown in
Figure 19.
2. Adjust hex nut shown in Figure 19 away from
shipping bracket to remove bracket.
Note: Bracket helps maintain headstock
alignment during shipping. Store bracket and
fasteners in case you need to move or ship
machine later.
Figure 19. Location of shipping bracket and
fasteners.
3. Attach handle to machine base with (4)
18 x 1 ⁄ " hex bolts, (8)
1
2
⁄ "-18 hex nuts (see Figure 20).
(4) 5
16
-20-
Shipping
Bracket
⁄ "-
5
16
⁄ " flat washers, and
5
16
Handle
x 4
Figure 20. Handle attached to machine base.
4. Insert round steel bar stock through (4) lifting
holes in machine base (see Figure 21).
Note: Bar stock must be at least
eter and 3 feet long. Otherwise, it may not
be big enough to properly support weight of
machine.
5. Attach lifting slings to steel bar stock and
power lifting equipment (see Figure 21).
Power Lifting
Equipment
Front
Lifting
Strap
Round
Steel Bar In
Lifting Holes
Figure 21. Example of lifting machine with forklift
and lifting slings.
6.
With assistant helping to stabilize load, lift
machine just high enough to clear pallet.
7. Remove pallet, then place wooden blocks
under machine so it will be supported 4" off
the ground, then lower machine.
Model G9743 (Mfd. Since 10/23)
⁄ " diam-
1
2
Rear
Lifting
Strap