Table of Contents
Advertisement
3. Attach the short upper and lower side
braces to one of the assembled side pan-
els. Use the M8 - 1.25 x 16mm Carriage
Bolts, 8mm Flat Washers and M8-1.25 Hex
Nuts supplied. See Figure 4.
Figure 4. Adding upper and lower side braces.
4. Bolt the other side panel to the upper and
lower braces using the M8-1.25 x 16mm
Carriage Bolts, 8mm Flat Washers and M8-
1.25 Hex Nuts supplied. See Figure 5.
Figure 5. Stand fully assembled.
-10-
5. Once the stand is assembled, hold the saw
body over the top of the stand to ensure the
mounting holes line up. If the holes line up,
tighten the stand fasteners. Once the stand
is securely tightened, set the saw on top
and insert the mounting bolts through the
mounting holes and secure with nuts and
washers. See Figure 6.
Figure 6. Fastening stand to saw body.
6. Level the stand by checking all sides for
symmetry. Measure diagonally from top to
bottom and adjust the stand so both diago-
nals are equal. Tighten all of the stand
bolts.
G5045 10'' Bench Top Table Saw
Advertisement
Table of Contents
