Assembly - Grizzly G0555 Owner's Manual

Assembly

The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
To assemble machine:
1.
Lay one stand side flat on a protective sur-
face, then attach the upper and lower stand
braces, as shown in Figure 8, with (8) M6-1
x 16 hex bolts, (8) 6mm flat washers, and (8)
M6-1 flange nuts.
Note: Only hand-tighten the stand fasteners
for now during these initial steps. Once the
stand is fully assembled you will be instructed
to fully tighten all fasteners.
Upper
Stand Brace
Figure 8. Upper and lower stand braces
attached to the stand side.
Model G0555 (Mfd. Since 5/11)
2.
3.
Lower
Stand Brace
x 8
Stand Side
Attach the remaining stand side to the assem-
bly, as shown in Figure 9, with (8) M6-1 x 16
hex bolts, (8) 6mm flat washers, and (8) M6-1
flange nuts.
Figure 9. Second stand side attached.
Install the foot assemblies into the holes in
the bottom of the stand assembly, using (2)
⁄ "-16 hex nuts and (2) 10mm flat washers,
3
8
as shown in Figure 10.
Note: Adjust the feet so that they are approxi-
mately the same height—this will make level-
ing the stand easier in a later step.
Figure 10. Stand foot installed (1 of 4).
x 4
-17-