Clean Up; Site Considerations - Grizzly G5045 Instruction Manual

Clean up

Unpainted machine surfaces may be coated with
a waxy oil to protect it from corrosion during ship-
ment. Remove this protective coating with a sol-
vent cleaner or citrus-based degreaser. Avoid
chlorine-based solvents as they may damage
painted surfaces should they come in contact.
Always follow the usage instructions on the prod-
uct you choose for clean up.
Many of the solvents commonly used to
clean machinery can be highly flammable,
and toxic when inhaled or ingested. Always
work in well-ventilated areas far from
potential ignition sources when dealing
with solvents. Use care when disposing of
waste rags and towels to be sure they do
not create fire or environmental hazards.
Keep children and animals safely away
when cleaning
machine.
Do not use gasoline or other petroleum-
based solvents to remove this protective
coating. These products generally have low
flash points which makes them extremely
flammable. A risk of explosion and burning
exists if these products are used. Serious
personal injury may occur.
G5045 10'' Bench Top Table Saw
and assembling

Site Considerations

1. Floor Load: Your G5045 10" Table Saw
represents a moderate weight load in a
small footprint. Most floors are suitable for
the table saw. Some older residential floors
may require additional build up to support
both machine and operator.
2. Working Clearances: Consider existing
and anticipated needs, size of material to
be processed through each machine, and
space for auxiliary stands, work tables or
other machinery when establishing a home
for your table saw. Allow sufficient room to
safely run your machines in any foresee-
able operation.
3. Lighting and Outlets: Lighting should be
bright enough to eliminate shadow and pre-
vent eye strain. Electrical circuits should be
dedicated or large enough to handle
amperage requirements. Outlets should be
located near each machine so power or
this
extension cords are clear of high-traffic
areas. Observe local electrical codes for
proper installation of new lighting, outlets,
or circuits.
Make your shop "child safe". Ensure that
your workplace is inaccessible to young-
sters by closing and locking all entrances
when you are away. Never allow visitors in
your shop when assembling, adjusting or
operating equipment. This saw is equipped
with a removable switch key. Remove it
from the saw and place it in a safe location
when the saw is not in use.
-7-